From 794b2fb40a577bf8658e854568c03f648e68d451 Mon Sep 17 00:00:00 2001 From: alphonse Date: Sun, 6 Apr 2025 00:56:49 +0000 Subject: [PATCH] Update Laser Controller --- Laser-Controller.md | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/Laser-Controller.md b/Laser-Controller.md index 94a135d..bb2d17f 100644 --- a/Laser-Controller.md +++ b/Laser-Controller.md @@ -5,9 +5,9 @@ The PAS has 3 lasers (blue, green, and red) that are all housed in a single modu ## Definitions and conventions * **Center Frequency:** The center frequecy should be set to the resonant frequency of the cell. The firmware will set the frequency of the green laser to the center frequency. It will set the frequency of the blue laser to the center frequency - 3 Hz and the red to the center frequency + 3 Hz. Must be an integer. -* **Blue Laser:** The laser connected to pin 0. -* **Green Laser:** The laser connected to pin 1. -* **Red Laser:** The laser connected to pin 2. +* **Blue Laser:** The laser connected to pin 1. +* **Green Laser:** The laser connected to pin 4. +* **Red Laser:** The laser connected to pin 9. * **Frequency Sweep:** Begin at center_frequency - n Hz and increase the frequency by 1 Hz every 2 seconds until reaching center_frequency + n, where *n* is any integer. *This is not currently useful -- use the sweep software instead!* * **Indicator LED:** By default, the Pico will flash the on-board LED when powered on. This may be turned off with `toggle.off`. * For ADC reads, the rate is hard-coded to 10000 S/sec and 1000 samples total.